Access Control
Access Control Lists
Cisco Small Business 300 Series Managed Switch Administration Guide 234
17
Creating ACLs Workflow
To create ACLs and associate them with an interface, perform the following:
1. Create one or more of the following types of ACLs:
a. MAC-based ACL by using the MAC Based ACL Page and the MAC Based
ACE Page
b. IP-based ACL by using the IPv4 Based ACL Page and the IPv4 Based ACE
Page
c. IPv6-based ACL by using the IPv6 Based ACL Page and the IPv6 Based
ACE Page
2. Associate the ACL with interfaces by using the ACL Binding Page.
Modifying ACLs Workflow
An ACL can only be modified if it is not in use. The following describes the process
of unbinding an ACL in order to modify it:
• If the ACL does not belong to a QoS Advanced Mode class map, but it has
been associated with an interface, unbind it from the interface using the ACL
Binding Page.
• If the ACL is part of the class map and not bound to an interface, then it can
be modified.
• If the ACL is part of a class map contained in a policy bound to an interface,
you must perform the chain of unbinding as follows:
- Unbind the policy containing the class map from the interface by using
Policy Binding.
- Delete the class map containing the ACL from the policy using the
Configuring a Policy (Edit).
- Delete the class map containing the ACL, by using Defining Class
Mapping.
Only then can the ACL be modified, as described in the sections of this chapter.
To Next Page
Loading...
Need help?
General
