Cisco SF500-24P - Built-In Smartport Macros

Smartport
Built-in Smartport Macros
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 192
11
Built-in Smartport Macros
The following describes the pair of built-in macros for each Smartport type. For
each Smartport type there is a macro to configure the interface and an anti macro
to remove the configuration.
Macro code for the following Smartport types are provided:
• desktop
• printer
• guest
• server
• host
• ip_camera
• ip_phone
• ip_phone_desktop
• switch
• router
• ap
desktop
[desktop]
#interface configuration, for increased network security and reliability when
connecting a desktop device, such as a PC, to a switch port.
#macro description Desktop
#macro keywords $native_vlan $max_hosts
#
#macro key description: $native_vlan: The untag VLAN which will be
configured on the port
# $max_hosts: The maximum number of allowed devices on
the port
#Default Values are
#$native_vlan = Default VLAN
#$max_hosts = 10
#
#the port type cannot be detected automatically
#
#the default mode is trunk
smartport switchport trunk native vlan $native_vlan
#
port security max $max_hosts