Access Control
IPv4-based ACLs
467 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
24
-
UDP
—User Datagram Protocol
-
HMP
—Host Mapping Protocol
-
RDP
—Reliable Datagram Protocol.
-
IDPR
—Inter-Domain Policy Routing Protocol
-
IPV6
—IPv6 over IPv4 tunneling
-
IPV6:ROUT
—Matches packets belonging to the IPv6 over IPv4 route
through a gateway
-
IPV6:FRAG
—Matches packets belonging to the IPv6 over IPv4 Fragment
Header
-
IDRP
—Inter-Domain Routing Protocol
-
RSVP
—ReSerVation Protocol
-
AH
—Authentication Header
-
IPV6:ICMP
—Internet Control Message Protocol
-
EIGRP
—Enhanced Interior Gateway Routing Protocol
-
OSPF
—Open Shortest Path First
-
IPIP
—IP in IP
-
PIM
—Protocol Independent Multicast
-
L2TP
—Layer 2 Tunneling Protocol
-
ISIS
—IGP-specific protocol
• Protocol ID to Match—Instead of selecting the name, enter the protocol ID.
• Source IP Address—Select Any if all source address are acceptable or
User defined to enter a source address or range of source addresses.
• Source IP Address Value—Enter the IP address to which the source IP
address is to be matched.
• Source IP Wildcard Mask—Enter the mask to define a range of IP
addresses. Note that this mask is different than in other uses, such as subnet
mask. Here, setting a bit as 1 indicates don't care and 0 indicates to mask that
value.
To Next Page
Loading...
