Need help?Do you have a question about the Cisco SG250-08HP and is the answer not in the manual?
General| Model | SG250-08HP |
|---|---|
| Type | Managed |
| Ports | 8 |
| Power over Ethernet (PoE) | Yes |
| PoE Ports | 8 |
| Total PoE Power Budget | 62W |
| Layer | Layer 2 |
| Switching Capacity | 16 Gbps |
| Forwarding Rate | 11.9 Mpps |
| VLAN Support | Yes |
| Power Supply | Internal |
| MAC Address Table Size | 8K entries |
| Jumbo Frame Support | Yes |
| Management | SNMP |
| Operating Temperature | 0 to 40 °C |
| Operating Humidity | 10% to 90% non-condensing |
Instructions for connecting network devices to the smart switch using Ethernet cables.
Information on PoE models, power requirements, port support, and PSE/PD considerations.
Steps to access and configure the switch via its web-based interface.
Using the ping command to test network reachability to the switch.
Troubleshooting steps for when the switch is not powering on.
Resolving problems related to switch IP address or network discovery.
Explanation of the System, Link/Act, 100M, Gigabit, XG, and PoE LED indicators.
To Next Page
