Need help?Do you have a question about the Cisco SG220-26 and is the answer not in the manual?
General| Model | SG220-26 |
|---|---|
| Category | Switch |
| Ports | 24 x 10/100/1000 + 2 x Gigabit SFP |
| Switching Capacity | 52 Gbps |
| Forwarding Rate | 38.69 Mpps |
| Layer | Layer 2 |
| PoE | No |
| Mounting | Rack-mountable |
| MAC Address Table Size | 8K entries |
| Power Supply | Internal |
| Management | Web-based |
| Jumbo Frame Support | 9216 bytes |
| Operating Temperature | 0°C to 40°C (32° to 104°F) |
| Storage Temperature | -20°C to 70°C (-4° to 158°F) |
| Humidity | 10% to 90%, non-condensing |
| Standards Compliance | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p |
Lists available Cisco 220 Series Smart Plus switch models and their port configurations.
Details the front panel layout including ports, indicators, and buttons.
Explains the function of front panel LEDs (System, Link/ACT, Speed) and the reset button.
Describes the power and console ports located on the rear of the switch.
Provides guidance on ambient temperature, air flow, and stability for switch placement.
Step-by-step instructions for securely mounting the switch in a standard 19-inch rack.
Instructions for wall-mounting non-PoE models using supplied brackets and user-supplied screws.
Details power sourcing capabilities, wattage limits, and supported standards for PoE models.
Lists default username, password, and IP address for initial switch access and setup.
Steps to access and configure the switch using its web interface via a browser.
Steps to configure the switch using the console port via a terminal emulation program.
Guides on testing network connectivity using ping and identifying common causes of connection problems.
Procedures to reboot or restore the switch to its original factory default settings.
Provides links to Cisco support, firmware downloads, product documentation, and warranty.
To Next Page
