Cisco 550X Series Stackable Managed Switches Quick Start Guide 15
Reset Button
The switch can be reset by inserting a pin or paper clip into the Reset
button opening on the front panel of the switch. See Returning the Cisco
550X Series Stackable Managed Switches to the Factory Default
Settings for details.
Back Panel
The power port and console port are located on the back panel of the
switch.
Power—Connects the switch to AC power.
RPS Port—Connects the switch to the Cisco RPS2300 module. The Cisco
RPS2300 can provide backup power to the switch when the main power
supply has a failure.
Console—Connects a serial cable to a computer serial port so that it can
be configured by using a terminal emulation program.
Returning the Cisco 550X Series
Stackable Managed Switches to the
Factory Default Settings
To use the Reset button to reboot or reset the switch, do the following:
• To reboot the switch, press and hold the Reset button for less than ten
seconds.
• To restore the switch to its factory default settings:
– Disconnect the switch from the network or disable all DHCP
servers on your network.
– With the power on, press and hold the Reset button for more than
ten seconds.
To Next Page
Loading...
