Administration: Discovery
Discover - LLDP
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 120
8
• PD Requested Power Value—Amount of power allocated by the PSE to the PD.
• PSE Allocated Power Value—Amount of power allocated to the sourcing equipment
(PSE).
802.3 Energy Efficient Ethernet (EEE) (If device supports EEE)
• Local Tx—Indicates the time (in micro seconds) that the transmitting link partner waits
before it starts transmitting data after leaving Low Power Idle (LPI mode).
• Local Rx—Indicates the time (in micro seconds) that the receiving link partner requests
that the transmitting link partner waits before transmission of data following Low
Power Idle (LPI mode).
• Remote Tx Echo—Indicates the local link partner’s reflection of the remote link
partner’s Tx value.
• Remote Rx Echo—Indicates the local link partner’s reflection of the remote link
partner’s Rx value.
4-Wire Power via MDI
• 4-Pair PoE Supported—Indicates system and port support enabling the 4-pair wire
(true only for specific ports that have this HW ability).
• Spare Pair Detection/Classification Required—Indicates that the 4-pair wire is
needed.
• PD Spare Pair Desired State—Indicates a pod device requesting to enable the 4-pair
ability.
• PD Spare Pair Operational State—Indicates whether the 4-pair ability is enabled or
disabled.
MED Details
• Capabilities Supported—MED capabilities supported on the port.
• Current Capabilities—MED capabilities enabled on the port.
• Device Class—LLDP-MED endpoint device class. The possible device classes are:
- Endpoint Class 1—Generic endpoint class, offering basic LLDP services.
- Endpoint Class 2—Media endpoint class, offering media streaming capabilities, as
well as all Class 1 features.
To Next Page
Loading...
Need help?
General
