Smartport
Configuring Smartport Using The Web-based Interface
185 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
10
Properties
To configure the Smartport feature globally:
STEP 1 Click Smartport > Properties.
STEP 2 Enter the parameters.
• Administrative Auto Smartport—Select to globally enable or disable Auto
Smartport. The following options are available:
- Disable—Select to disable Auto Smartport on the device.
- Enable—Select to enable Auto Smartport on the device.
- Enable by Auto Voice VLAN—This enables Auto Smartport, but puts it in operation
only when Auto Voice VLAN is also enabled and in operation. Enable by Auto
Voice VLAN is the default.
• Operational Auto Smartport—Displays the Auto Smartport status.
• Auto Smartport Device Detection Method—Select whether incoming CDP, LLDP, or
both types of packets are used to detect the Smartport type of the attaching device(s). At
least one must be checked in order for Auto Smartport to identify devices.
• Operational CDP Status—Displays the operational status of CDP. Enable CDP if Auto
Smartport is to detect the Smartport type based on CDP advertisement.
• Operational LLDP Status—Displays the operational status of LLDP. Enable LLDP if
Auto Smartport is to detect the Smartport type based on LLDP/LLDP-MED
advertisement.
• Auto Smartport Device Detection—Select each type of device for which Auto
Smartport can assign Smartport types to interfaces. If unchecked, Auto Smartport does
not assign that Smartport type to any interface.
STEP 3 Click Apply. This sets the global Smartport parameters on the device.
To Next Page
Loading...
Need help?
General
