Cisco SGE2000 Administration Guide

Chapter
3
21
Chapter 3: Connecting the Switch
Configuring Units and Ports
Linksys One Ready Communications Solution
Setting the Unit’s Operational Mode
Use the GUI to set the unit’s operational mode to standalone or stack. This configuration
takes effect after the next reboot.
Configuring the Stack Master and Unit ID
Stack Management
The Stack Management Page allows network managers to either reset the entire stack or a
specific device. Device configuration changes that are not saved before the device is reset
are not saved. If the Stack Master is reset, the entire stack is reset.
To open the Stack Management Page:
1.
Click System > System Management > Stack Management. The Stack Management Page
opens:

Cisco SGE2000 Specifications

General

Jumbo Frame Support	9KB
VLANs	Up to 256
Management	Web-based, SNMP, CLI
Standards	IEEE 802.3, 802.3u, 802.3ab, 802.3z, 802.3x, 802.1D, 802.1Q, 802.1p, 802.1w
Dimensions	440 x 44 x 257 mm
Power Supply	100 to 240V AC, 50-60 Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Humidity	10% to 90% non-condensing
Weight	3.2 kg