Cisco SGE2000 Administration Guide

Chapter
4
37
Chapter 4: Console Configuration
Configuring the Switch through the Console or Telnet Interface
Linksys One Ready Communications Solution
Versions
Use the Versions screen to display the boot, software, and hardware firmware versions
of the Ethernet switch. In stacking mode, this information is displayed for the stack
master.
General System Information
Use the General System Information screen to display the description, System Up Time,
System MAC Address, System Contact, System Name, and System Location of the
Ethernet switch.
To change general system information:
a. Select Edit to make changes.
b. When your changes are complete, press the Esc key to return to the Action menu
c. Select Save to save your changes.
Management Settings
From the Management Settings screen, you can set Serial Port Session Configuration,
Telnet Session Configuration, or Secure Telnet (SSH) Configuration.

Cisco SGE2000 Specifications

General

Jumbo Frame Support	9KB
VLANs	Up to 256
Management	Web-based, SNMP, CLI
Standards	IEEE 802.3, 802.3u, 802.3ab, 802.3z, 802.3x, 802.1D, 802.1Q, 802.1p, 802.1w
Dimensions	440 x 44 x 257 mm
Power Supply	100 to 240V AC, 50-60 Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Humidity	10% to 90% non-condensing
Weight	3.2 kg