Cisco SGE2010P User Manual

Switch Firmware Upgrade via TFTP
Document ID: 108853
Questions
Introduction
How do I upgrade the firmware of the switch via TFTP?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business
products (formerly Linksys Business Series).
Note: The firmware version, type, and user interface used in this example might be different than the
firmware version, type, and user interface for these switches: SRW208, SRW208G, SRW208L, SRW208P
and SRW208MP, SRW2008, SRW2008P and SRW2008MP, SRW2024, SRW2048, SRW2016, SRW224G4,
SRW248G4, SFE1000P, SFE2000, SFE200P, SFE2010, SFE2010P, SGE2000, SGE2000P, SGE2010, and
SGE2010P.
Refer to Cisco Technical Tips Conventions for information on document conventions.
Q. How do I upgrade the firmware of the switch via TFTP?
A. Complete these steps in order to upgrade the switch firmware via TFTP:
Check the model and version number at the back of the switch.
Note: If there is no hardware version displayed beside the model number, the device
is considered version 1.
1.
Go to Cisco Software Center (
registered customers only
) . Cisco recommends that you
perform all firmware upgrades on your local network, not remotely.
Note: You need a registered account to login. If you do not already have one, please
register at Cisco.com.
Device Name Firmware
Version URL
File Name URL
SRW208 ls_srw208_8fe−104.ros
2.

Cisco SGE2010P Specifications

General

Model	SGE2010P
Type	Managed
PoE Ports	48
Layer	Layer 2
Power Over Ethernet (PoE)	Yes
MAC Address Table Size	8K
Jumbo Frame Support	Yes
VLANs Supported	256
Form Factor	Rack-mountable
Quality of Service (QoS)	Yes
Power Supply	Internal
Management	Web, CLI
Security Features	ACL
Dimensions (W x D x H)	440 x 300 x 44 mm
Operating Temperature	0°C to 45°C (32 to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Humidity	10% to 90% (non-condensing)
Ports	48 x 10/100/1000

Summary

Introduction to Cisco Small Business Products

Overview of Cisco Small Business Products

Article describes setup, troubleshooting, and maintenance for Cisco Small Business products.

Note on Firmware Version Differences

Example may differ from actual firmware versions for various Cisco switches.

Upgrade Switch Firmware via TFTP

Check Device Model and Version

Verify the model and version number on the back of the switch.

Download Firmware and Install TFTP Server

Download firmware file and install TFTP server software on your computer.

Configure TFTP Server and Upload Firmware

Save firmware to TFTP-Root, access switch UI, select TFTP upgrade, and input server/file details.