See also the required VIC Slot setting below.
• VIC Slot—If you use the Cisco Card NIC mode, you select this setting to match where your VIC is
installed. The choices are Riser1, Riser2, or Flex-LOM (the mLOM slot).
◦
If you select Riser1, slot 1 is used.
◦
If you select Riser2, slot 2 is used.
◦
If you select Flex-LOM, you must use an mLOM-style VIC in the mLOM sl
NIC Redundancy
This server has the following NIC redundancy settings that you can choose from:
• None—The Ethernet ports operate independently and do not fail over if there is a problem. This setting
can be used only with the Dedicated NIC mode.
• Active-standby—If an active Ethernet port fails, traffic fails over to a standby port.
• Active-active—All Ethernet ports are utilized simultaneously. Shared LOM EXT mode can have only
this NIC redundancy setting. Shared LOM and Cisco Card modes can have both Active-standby and
Active-active settings.
The active/active setting uses Mode 5 or Balance-TLB (adaptive transmit load balancing). This is channel
bonding that does not require any special switch support. The outgoing traffic is distributed according
to the current load (computed relative to the speed) on each slave. Incoming traffic is received by the
current slave. If the receiving slave fails, another slave takes over the MAC address of the failed receiving
slave.
Install Cisco ISE Software on the SNS 3515 and SNS 3595
Appliances
Install Cisco ISE on the Cisco SNS 3515 or 3595 Appliance
The Cisco SNS 3515 and Cisco SNS 3595 appliances are preinstalled with the ISE 2.0.1 software. This section
gives you an overview of the installation process and the tasks that you must perform before installing ISE.
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
30
Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
To Next Page
Loading...
Need help?
General