Need help?Do you have a question about the Cisco SPA502 and is the answer not in the manual?
Access names and numbers, create new entries, and search for contacts.
Connect to MessageBank to manage greetings and listen to voicemail messages.
Transfer an active call to another party by entering their number.
Answer calls ringing on another phone from any phone in the office.
Add a third party to an active call to establish a conference call.
Place a call on hold and pick it up from another phone in the office.
Connect handset, stand, power, and network cables to the phone unit.
Configure user profile by entering Device ID and Password for initial setup.
Connect phone using an Ethernet cable for a wired network connection.
Connect phone to a wireless network using Wi-Fi Protected Setup (WPS).
Turn on Bluetooth, select user preferences, and configure Bluetooth settings.
Search for profiles, scan, select device, enter PIN, and connect to the phone.
General| Lines | 2 |
|---|---|
| Power over Ethernet | Yes |
| Headset Support | Yes |
| Protocols | SIP |
| Speakerphone | Yes |
| Weight | 1.5 lbs |
| Headset Port | 2.5 mm |
| Audio Codec Support | G.711, G.729 |
| Headset Jack | Yes, 2.5 mm |
| Power Supply | optional |
| Ethernet Ports | 2 (10/100 Mbps) |
To Next Page
