URLCommands
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/
interface/command/ir-cr-book/
ir-c1.html#wp7026926390
channelized
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/
interface/command/ir-cr-book/
ir-l1.html#wp1033903426
loopback
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/
interface/command/ir-cr-book/
ir-s3.html#wp2149471094
show controller t1
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/
interface/command/ir-cr-book/
ir-s2.html#wp1632676058
show controller e1
Additional References for Configuring 48-Port T1/E1 CEM
Interface Module
Related Documents
Document TitleRelated Topic
Cisco IOS Master Commands List, All Releases
Cisco IOS commands
Standards and RFCs
TitleStandard/RFC
There are no standards and RFCs for this feature.
—
MIBs
MIBs LinkMIB
To locate and download MIBs for selected platforms, Cisco IOS releases, and feature sets, use Cisco
MIB Locator found at the following URL:
http://www.cisco.com/go/mibs
—
48-Port T1/E1 CEM Interface Module Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
14
Configuring T1/E1 Interfaces on 48-Port T1/E1 Interface Module
Additional References for Configuring 48-Port T1/E1 CEM Interface Module
To Next Page
Loading...
Need help?
General
