Cisco T1

CONTENTS
Configuring T1/E1 Interfaces on 48-Port T1/E1 Interface Module 1
CHAPTER 1
Information About T1/E1 Interfaces 1
Overview of T1/E1 Interfaces 1
Restrictions for Configuring T1/E1 Interfaces 1
How to Configure T1/E1 Interfaces 2
Setting the Card Type 2
Configuring the Controller 2
Verifying the Controller Configuration 3
Configuring Structure-Agnostic TDM over Packet - T1/E1 Interfaces 3
Verifying CEM Configuration for SAToP 3
Performance Monitoring 4
Circuit Emulation Service over Packet-Switched Network 4
Restrictions for CESoPSN on T1 Interface 5
Configuring CEM Group for CESoPSN on T1 Interface 5
Verifying CEM for CESoPSN on T1 Interface 6
Troubleshooting T1/E1 Controllers 7
Running Bit Error Rate Testing for SAToP 7
Configuring BERT for SAToP 8
Bit Error Rate Testing for CESoPSN 9
Restrictions for BERT in CESoPSN 9
Configuring BERT for CESoPSN 10
Verifying BERT Configuration for CESoPSN 10
Loopback on T1/E1 Interfaces 11
Configuring Loopback 12
Associated Commands 13
Additional References for Configuring 48-Port T1/E1 CEM Interface Module 14
48-Port T1/E1 CEM Interface Module Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
iii