Overview of Circuit Emulation 17
CHAPTER 2
Configuring Pseudowire 17
Information About Pseudowire 17
Restrictions for CEM 17
Overview of Pseudowire 18
How to Configure Pseudowire 18
Structure-Agnostic TDM over Packet 18
Circuit Emulation Service over Packet-Switched Network 21
Associated Commands 24
Additional References for Configuring Pseudowire 25
Alarm History 27
CHAPTER 3
Alarm History Restrictions 27
Configuring Alarm History 28
Verification of Alarm History Configuration 28
Associated Commands 29
Additional References for Alarm History 29
Clock Recovery System for SAToP 31
CHAPTER 4
Finding Feature Information 31
Information About Clock Recovery 31
Adaptive Clock Recovery (ACR) 31
Differential Clock Recovery (DCR) 32
Benefits of Clock Recovery 32
Prerequisites for Clock Recovery 33
Restrictions for Clock Recovery 33
How to Configure ACR and DCR 33
Configuring ACR for T1/E1 33
Configuring Adaptive Clock Recovery of T1/E1 Interfaces for SAToP 33
Configuring DCR for T1/E1 34
Configuring Differential Clock Recovery of T1/E1 Interfaces for SAToP 34
Configuring Network Clock 36
Verifying Network Clocking Configuration 36
48-Port T1/E1 CEM Interface Module Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
iv
Contents
To Next Page
Loading...
Need help?
General
