Cisco UCS C22 - Page 16

1-2
Cisco UCS C22 Server Installation and Service Guide
OL-26646-01
Chapter 1 Overview
Figure 1-2 shows the rear panel features of the server.
Figure 1-2 Rear Panel Features
Table 1-1 lists the features of the server.
.
1 Power supply 6 Serial port (DB-9 connector)
2 PCIe slot 2 on riser 2
(half-height, half-length, x8 lane)
7 VGA video port (DB-15 connector)
3 PCIe slot 1 on riser 1
(full-height, half-length, x16 lane, 
supports NCSI)
8 10/100/1000 Base-T Ethernet dedicated
management port
4 Dual 1-Gb Base-T Ethernet ports (two) 9 Rear Identification button/LED
5 USB 2.0 ports (four) –
PSU 1PSU 1PSU 1
PCIe 2
PCIe 2PCIe 2 PCIe 1PCIe 1PCIe 1
1 2 3
654 7 8 9
302159
Ta b l e 1-1 Cisco UCS C22 Server Features
Chassis One rack-unit (1RU) chassis.
Processors One or two Intel Xeon E5-2400 Series processors.
Memory The server provides 12 DIMM
1
sockets on the motherboard.
Note In a single-CPU configuration, only 6 DIMM slots are active.
Baseboard
management
Pilot III BMC, running Cisco Integrated Management Controller (CIMC) firmware.
Depending on your CIMC settings, the CIMC can be accessed through the 
1-Gb Ethernet dedicated management port, the dual 1-Gb Ethernet LOM ports, or a
Cisco P81E virtual interface card.
Network and
management I/O
The server provides these rear-panel connectors:
• One 10/100/1000 Base-T Ethernet dedicated management port
• Two 1-Gb Base-T Ethernet ports
• One RS-232 serial port
• One VGA
2
video connector
• Four USB
3
2.0 connectors
There are also two USB 2.0 ports on the front panel.
Power One 450 W power supply or one 650W power supply.
See also Power Specifications, page A-2.
Cooling Five fan modules for front-to-rear cooling.