C-9
Cisco UCS C22 Server Installation and Service Guide
OL-26646-01
Appendix C      RAID Controller Considerations
Embedded RAID Controller
Disabling the Embedded RAID Controller in the BIOS
Caution Data migration from SW RAID to HW RAID is not supported and could result in data loss. Migrations 
from SW RAID to HW RAID are supported only before there is data on the drives, or the case in which 
there are no drives in the server. 
If you change from using this embedded controller to a RAID controller card, you must disable the 
embedded controller in the server BIOS. 
Note The embedded RAID controller uses different cables than the PCIe card controllers. See Supported 
RAID Controllers and Required Cables, page C-2 and RAID Controller Cabling, page C-17.
Use the following procedure to disable the LSI MegaSR drivers.
Step 1 Boot the server and press F2 when prompted to enter the BIOS Setup utility.
Step 2 Select the Advanced tab, then South Bridge.
Step 3 Set Onboard SATA Controller to Disabled. 
Step 4 Press F10 to save your changes and exit the utility.
Launching the LSI Embedded RAID Configuration Utility
Launch the utility by pressing Ctrl+M when you see the prompt during system boot.
For more information about using the Embedded MegaRAID software to configure your disk arrays, see 
the 
LSI Embedded MegaRAID Software User Guide.
Installing LSI MegaSR Drivers For Windows and Linux
Note The required drivers for this controller are already installed and ready to use with the LSI SWRAID 
Configuration Utility. However, if you will use this controller with Windows or Linux, you must 
download and install additional drivers for those operating systems.
This section explains how to install the LSI MegaSR drivers for the following supported operating 
systems:
  • Microsoft Windows Server 2008R2
  • Red Hat Enterprise Linux (RHEL) 5.7, 6.1, and 6.2
  • SuSE Linux Enterprise Server (SLES) 11 (SP1 and SP2)
This section contains the following topics:
  • Downloading the LSI MegaSR Drivers, page C-10
  • Microsoft Windows Driver Installation, page C-10
  • Linux Driver Installation, page C-12