Cisco UCS C220 M4

C-15
Cisco UCS C220 M4 Server Installation and Service Guide
OL-32473-01
Appendix C RAID Controller Considerations
Embedded SATA RAID Controllers
Disabling the Embedded RAID Controller in the BIOS
Step 1 Boot the server and press F2 when prompted to enter the BIOS Setup Utility.
Step 2 Select the Advanced tab, and then select LOM and PCIe Slots Configuration.
Step 3 Set PCH SATA Mode to Disabled.
Step 4 Press F10 to save your changes and exit the utility.
Launching the LSI Embedded RAID Configuration Utility
Launch the LSI utility by pressing Ctrl-M when you see the prompt during system boot.
For information about using the Embedded MegaRAID software to configure your disk arrays, see the
LSI Embedded MegaRAID Software User Guide.