Cisco UCS S3260 Service Manual

3-17
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
Chapter 3 Maintaining the System
Installing or Replacing System Components
Setting Up Booting in UEFI Mode in the Cisco IMC GUI
Step 1 Use a web browser and the management IP address of the system to log into the Cisco IMC GUI
management interface.
Step 2 Select Compute and then Server 1.
Step 3 Select the BIOS tab.
Step 4 Under BIOS Properties, set Configured Boot Order to UEFI.
Step 5 Click Save Changes.
Step 6 Click Configure Boot Order.
Step 7 Select the Advanced tab.
Step 8 Click Add Local HDD.
Step 9 In the Add Local Disk dialog, enter the information for the 4K sector format drive. Enter a name and
specify Slot M.
Step 10 Click Save Changes.
Step 11 Click Add Virtual Media.
Step 12 In the Add Virtual Media dialog, enter a name for your OS installation virtual media.
Step 13 Click Save Changes.
Step 14 Click Close.
Step 15 Click Launch KVM to open a virtual KVM window for the server node.
Step 16 In the Launch KVM dialog, select Server 1 and click Launch.
Step 17 Activate virtual media. Pull down the Virtual Media menu on the KVM window and select Activate
Virtual Devices.
Step 18 Reboot the server node.
Step 19 Press F6 during the boot to enter the boot device menu.
Step 20 Select UEFI: Cisco vKVM-Mapped vDVD and press Enter.
Step 21 Proceed with the installation of your OS.
After the OS installs and the system reboots, your OS is listed as a boot option.

Cisco UCS S3260 Specifications

General

Drive Bays	Up to 56
Maximum Storage Capacity	Up to 600 TB
Power Supply	Up to 4 hot-plug power supplies
Product Type	Storage Server Chassis
Supported Drives	SAS, SATA
Processors	Up to two Intel Xeon Scalable processors
Memory	Up to 1.5 TB DDR4 RAM
Power Supplies	Redundant 80+ Platinum power supplies
Total Drive Bays	56
Management	Cisco UCS Manager
Compatibility	Cisco UCS system
Form Factor	4U rack