27
Cisco Unified Access CT5760 Controllers and Catalyst 3850 Switches Web GUI Deployment Guide, Cisco IOS XE Software Release 3.2.2
Configuration Examples
Step 38 You can configure SNMP trap in this section, give a Location and Contact to proceed to next step.
Step 39 Management Interface Configuration—You can use the out of band Management Port to access the
switch. Enter the IP address/Netmask shown in the screen below and proceed to next screen for
Wireless management configuration.
Step 40 Wireless Management Configuration—Here, you can configure Wireless Management interface on the
3850 and assign it for a specific VLAN. Assign VLAN IP and default gateway.
Note AP is connected to Interface Gig1/0/3 marked as access port.
To Next Page
Loading...
