You can download the Windows driver here .
To use the USB console from a Macintosh device:
1. Install the USB serial drivers attached here .
2. Launch the Terminal utility.
3. From a terminal shell, access the console port with this command:
$ screen /dev/tty.usbserial* 115200,cs8
Maintenance and Troubleshooting
You can monitor and troubleshoot the vEdge 100wm router using the various LEDs and system alarms on
the router.
Alarm Severity Levels
The system alarms on the vEdge 100wm router have two severity levels:
Hardware Installation Guide for vEdge Routers
105
vEdge 100wm Router
Maintenance and Troubleshooting
To Next Page
Loading...
Need help?
General
