Cisco vEdge 100m - Vedge 1000 Router Default Configuration

1. Connect one end of the Ethernet cable to the management port, labeled MGMT, on the vEdge router (see
Figure 4). The management Ethernet port is a 10/100/1000 Mbps port that supports autonegotiation.
2. Connect the other end of the Ethernet cable to the management device.
Figure 4: Connecting the vEdge 1000 Router to a Network for Out-of-Band Management
vEdge 1000 Router Default Configuration
The default configuration file looks like this:
vEdge1000# show running-config
system
vbond ztp.viptela.com
aaa
auth-order local radius tacacs
usergroup basic
task system read write
task interface read write
!
usergroup netadmin
!
usergroup operator
task system read
task interface read
task policy read
task routing read
task security read
!
user admin
password
$6$t.vzhbSwOUaaCnRu$<wbr/>AiJYG3VFR1NurXPY7YXSputMMv4hg3<wbr/>Bign362rj4IIWXm7uVfiReqv/<wbr/>4EhKG2QUJSaZnZZPveQYBfIozCioyE<wbr/>/
!
!
logging
disk
enable
!
!
Hardware Installation Guide for vEdge Routers
149
vEdge 1000 Router
vEdge 1000 Router Default Configuration