Index
IN-2
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-11
DB-9 adapter 12
DISK LED, Sup Eng 720, Sup Eng 32 16, 23
DRAM, default 5
E
EEPROM 5, 7
EIA/TIA-232 transmission speeds 10
environmental monitoring 14
environmental specifications (table) 1
ESD, preventing damage 2
excessive link spans 19
F
fault tolerance and redundancy 4
fiber optics
cleaning
18, 19
connectors 16
filler plate, module 6, 7
flash memory cards 12, 13, 14
front panel
console port mode switch
10
disk slots 12
LEDs 22
Reset button 15, 22
Sup2 (figure) 15, 23
uplink ports 22
front panel controls 22
RSP720, Sup720, Sup32 22
Sup2 15, 24
G
GBICs, connecting to 10
Gigabit Ethernet cables 7, 9, 10
H
hot swapping
Cisco 7600 series router components
6
modules 8
supervisor engines and RSPs 8
http
//www.cisco.com/en/US/docs/ios/ha/command/refere
nce/ha_book.html
12
//www.cisco.com/en/US/docs/ios/qos/command/refer
ence/qos_book.html
13
I
installing
flash memory cards
13
modules 4
patch cord 20
interfaces, addresses of 6
L
LC connectors 17
LEDs
ACTIVE
16, 23
CONSOLE 25
DISK (Sup Eng 720, Sup Eng 32 only) 16, 23
front panel 22
LINK 16, 23, 25
PCMCIA (Sup Eng 2 only) 25
PWR MGMT 16, 23, 25
RSP720, Sup720, Sup32 22
STATUS 16, 22, 24
Sup2 16, 24
SWITCH LOAD (Sup Eng 2 only) 25
SYSTEM 16, 22, 25
LINK LED
To Next Page
Loading...
Need help?
General
