B-6
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-11
Appendix B Cable and Connector Specifications
Uplink Port Transceiver Modules
1GE Uplink Ports and Cabling Specifications
Table B-4 describes the 1GE SFP transceiver modules that are used for Cisco 7600 uplink ports.
Table B-5 provides cabling specifications.
Note Use Category 5 Shielded Twisted Pair cable at the port that supports the10/100/1000-Mbps RJ-45
connector for the RSP720-10GE.
SUP 2T
10GE Uplink Ports:
X2-10GB-SR
X2-10GB-LR
X2-10GB-ER
X2-10GB-LX4
X2-10GB-CX4
X2-10GB-LRM
X2 10GB-ZR
1GE Uplink Ports:
GLC-SX-MM
GLC-LH-SM
GLC-ZX-SM
GLC-T
GLC-BX-D
GLC-BX-U
SFP-GE-S
SFP-GE-L
SFP-GE-T
Supervisor Engine 32
10GE Uplink Ports (WS-SUP32-10GE-3B only):
XENPAK-10GB-CX4
XENPAK-10GB-SR
XENPAK-10GB-LX4
XENPAK-10GB-LR
XENPAK-10GB-ER
1GE Uplink Ports (WS-SUP32-GE-3B):
GLC-SX-MM
GLC-LH-SM
GLC-ZX-SM
GLC-T
Supervisor Engine 2 1000BASE-X GBIC modules, which are preinstalled
Table B-3 Uplink Port Transceiver Modules (continued)
Supervisor Engine or RSP Transceiver Module Part Numbers
To Next Page
Loading...
