Citizen 87 - Leap Year Adjustment; Using the Alarm; Setting the Alarm

■ USING THE ALARM
The alarm sounds once a day for 15
seconds at the alarm time set.
Pressing any of buttons A, B or C stops
the alarm ringing.
Setting the Alarm
Alarm setting is on a 24-hour system in 1
minute.
The hands are moved thus: minute hand →
hour hand → 24-hour hand.
1. Press button M to set the mode hand to
<ALM> and switch to the alarm mode.
2. Pull button M out, to the alarm set time adjusting state.
3. Press button B or C to set the minute, hour and 24-hour hands to the
desired time.
19
* Since the date and function hand are synchronized with each other, the
function hand will turn at when correcting the date.
* Date correction at the end of each month is not required. However, since
February is set at 28 days, date correction must be performed for
February only in leap years.
Leap year adjustment
1. Press button M to change the mode to <CAL>.
2. Pull out button M by one click.
3. Press button C for more than two seconds to set/cancel the leap year.
• The leap year is set if button C is continuously pressed when March 1 is
displayed.
• The leap year is canceled if button C is continuously pressed when
February 29 is displayed.
4. Push button M back into normal position.
* Once the leap year is set, February 29 is displayed once in every four
years.
18
24
6
12
18
A
L
M
W
A
R
N
I
N
G
S
E
T
S
T
O
P
C
H
A
R
G
E
ON
OFF
7
0
2
46
8
A
L
M
T
M
E
C
H
R
A
L
M
T
M
E
C
A
L
C
A
L
C
H
R
M
BA
C