Time Setting Warning Function
When the watch is recharged by exposing it to light after once stopped, the
second hand moves to the ▲ SET position, indicating that the watch does
not keep correct time. (Time setting warning display)
* The hour, minute and 24-hour hands run at the incorrect time.
Refer to page 25, “■ In These Cases”.
Overcharge Prevention Function
You can recharge without worry.
When the secondary battery is fully recharged, the overcharging prevention
function works so that the secondary battery is not overcharged.
7
Insufficient Charge Warning Function
If the watch is put in the undercharged state during any display mode, it
switches to the time display when in other display modes, then the second
hand moves to the ▲ CHARGE position, indicating the shortage of
electricity. (Electric power shortage warning display) Even then, the time
(hour, minute and 24-hour hands) runs accurately.
* The alarm does not ring even if it is set.
* If the chronograph is being used, measurement stops and it is reset.
* The push button does not function.
Refer to page 25, “■ In These Cases”.
Stop Warning Function
If the watch is left intact in the undercharged state, about 5 days later the
second hand will move to the ▲ STOP position, indicating that the watch has
stopped due to electric power shortage. (Stop warning display)
The other hands (hour, minute and 24-hour hands) also stop.
* In this condition, all functions stop.
Refer to page 25, “■ In These Cases”.
6
To Next Page
Loading...
