23
Chronograph Measurement
Chronograph standard or accumulated
elapsed time measurement
1. Press button M to set the mode hand
to <CHR> and get the chronograph
display.
At this time, the second hand and the
function hand will return to the “0”
position.
* The hour, minute and 24-hour hands
show the present time.
2. Each time button A is pressed, it repeatedly starts or stops the
chronograph, along with a confirmation sound.
How to read each chronograph hand if the measured time when the
chronograph is stopped is over 1 minute
1 Read the number of minutes with the function hand
2 Read the number of seconds with the second hand
22
3 While pressing button B continuously, the function hand switches to 1/20
(0.05) second hand measurement, so read the value at that time.
When button B is released, the function hand resumes showing
chronograph minutes.
3. While the chronograph is stopped state, pressing button C resets the
function hand and the second hand to the 0 position.
Reset
Pressing button A to
repeat the chronograph
start and stop cycle.
AA
C
Stop
Start
To Next Page
Loading...
