25
24
13. When These Problems Occur ...
<The Watch Shows Abnormal display>
When the battery life is close to expiring, the display or functions may become abnormal.
When these problems occur, replace the battery as soon as possible.
In rare cases, a strong impact, etc. may cause the display or functions to become abnor-
mal (no display, alarm sounds incessantly, etc.). In this case, perform the all-reset opera-
tion by referring to "14. All-Reset Operation".
<Following Battery Replacement>
After the battery has been replaced, perform the all-reset operation by referring to "14.
All-Reset Operation".
<How to Zone Settings>
(1) Press the M button to move to the <SET> mode.
(2) Press the B button to recall the city that you want to set.
(3) When the B button is pressed for more than 2 seconds, the "ON" or "OFF" and the
"city name" will flash.
Press the A button to select whether the city should be displayed (ON) or not (OFF).
(4) When the B button is pressed while the "city name" and "ON", or "OFF", are flashing,
the "S.T. (Summertime symbol)" and "ON", or "OFF", will start flashing. Press the A
button to select whether Summertime should be set (ON) or canceled (OFF).
*To set other cities, press the B button again to move to the adjustment mode for the
next city. Follow the same procedure in sequence to set each of the desired cities.
(5) When all the desired cities have been set, press the M button again to return to the
normal zone setting display.
* The zone setting adjustment mode (flashing display) will automatically return to the
normal display if left for more than two minutes with no input.
To Next Page
Loading...
Need help?
General
