F. HOW TO USE THE ALARM
Once the alarm has been set, it will sound every day at the set time for 15 sec-
onds. However, it will not sound in Diving Modes.
The alarm sound can be stopped by pressing any button.
< Setting the alarm time >
(1) Press button
M
to set the Alarm Mode.
(2) If you press button
B
for 2 seconds or more,
the hour display flashes on and off and the
watch is in the alarm time adjustment state.
(3) Press button
A
to adjust the hour display.
(The flashing figures can be adjusted.)
(4) If you press button
B
, the figures which are
flashing change to the minute display.
(5) Press button
A
to adjust the minute display.
Keep the button
A
pressed down to adjust
quickly.
(6) Press button
B
or button
M
to return to the
normal display. Alarm time setting is now
completed.
E. HOW TO SET THE ANALOG TIME
[Setting the analog time]
(1) Loosen the screw of the crown and pull it
out so that the second hand stops in the
“0” position.
(2) Turn the crown to set the time.
(3) When the seconds on the digital time dis-
play read “0”, push the crown in to start
the hands.
(4) After setting the time, always lock the
crown.
Screw Lock Crown
• When operating the crown, loosen the crown’s screw first.
• Return the crown to its normal position after operation, and always lock it.
• Do not operate any button when the crown is pulled out.
• Do not operate the crown when there are drops of water on the watch or
when it is underwater. Water can get inside the watch and result in malfunc-
tion and damage.
26
27
Time adjusting
position
To Next Page
Loading...
Need help?
General
