* In addition, this watch has a ascending speed warning function which alarm
sounds for 10 seconds to warn you if the ascending speed exceeds 1.5m
(5ft) in 10 seconds.
* Be careful when using the various kinds of alarms because their sound
might be difficult to hear depending on the surrounding circumstances (such
as the sound of bubbles) or the way the watch is carried.
1. HOW TO SET THE DEPTH ALARM
(1)
Press button
M
to switch to the Depth Alarm Mode.
The depth display flashes on and off.
(2) Press button
A
to display the depth at which
you want the alarm to sound. Depth alarm
setting is now completed.
Each time you press button
A
, you can adjust
the depth in increments of +1m (5ft) from 1 ➡ 2
➡ 3 ... 79 ➡ 80 ➡ -- ➡ 1 ... . (5 ➡ 10 ➡ 15 ...
255 ➡ 260 ➡ ... 5)
You can adjust quickly by keeping button
A
pressed down.
* Display “--” for the depth alarm not to sound.
I. HOW TO USE THE DEPTH/DIVING TIME ALARM
There are the following 2 alarm functions in this watch’s Diving Modes.
1 Depth alarm function: • Set range: 1m-80m/5ft-260ft (1m/5ft units)
• The alarm sounds for 15 seconds when you
reach the set depth while diving.
After the alarm sounds once, if you continue
diving deeper than the set depth then the alarm
repeatedly sounds for 15 seconds every 1
minute.
If you return to a shallower point than the set
depth, the alarm stops.
2 Diving time alarm function: • Set range: 5-310 minutes (5 minute units)
• The alarm sounds for 30 seconds when you
exceed the set time after the dive starts.
* This alarm only sounds once.
✩ You can stop both the depth alarm and the diving time alarm by pressing
button
A
.
36
37
To Next Page
Loading...
Need help?
General
