[When ER (error) is displayed during use]
• When ER is displayed during use on land or when the watch is switched to
Diving Modes.
• When the ER display is not cancelled even a long time after a dive is fin-
ished.
In the above cases, there might be something wrong with the pressure sensor.
In such a case, stop using the watch and consult someone at the place of pur-
chase or your nearest Citizen Service Center.
[You cannot switch to another mode from Dive Mode]
If there is a pressure change of 1m/4ft or more while in Dive Mode in an envi-
ronment where pressure changes occur for short periods of time (high altitude,
in the airplane), the water depth measurement display does not return to 0.0m
(0ft) even when you land, and you might be unable to cancel Dive Mode.
If this happens, pull out the crown and Dive Mode will be cancelled.
If you cancel Dive Mode in this way, the log data will not be recorded.
47
L. IN CASE OF THE FOLLOWING
[The second hand moves at 2-second intervals]
The battery is nearing the end of its life, and the low battery warning device is
working.
When this happens, replace the battery as soon as possible.
(Even when this happens, the watch still keeps the correct time.)
Note that the following cannot be done when the watch is in this state.
1. The alarms do not sound.
2.You can switch to Diving Modes, but not to Dive Mode.
3. If this function is activated with the depth measurement display, the diving
alarm will not sound. If this happens, stop diving.
Request battery replacement by Citizen at the place of purchase or
send directly to a Citizen Service Center.
46
To Next Page
Loading...
