M. ALL RESET
All Reset cancels all stored data, so please record any necessary
data in a logbook beforehand.
(1) Pull the crown out.
(2) Press all three buttons simultaneously, then
release them.
(3) Push the crown in to its normal position.
There will be a confirmation beep.
All data is erased after All Reset, so set
each mode again correctly before use.
49
[If the watch’s display or operation is abnormal]
If a strong impact or strong static electricity is applied to the watch, abnormal
display or operation (such as the digital display malfunction or the alarm
continuing to sound) might occur on a rare occasion.
If this happens, carry out “M. ALL RESET”.
[After battery replacement]
After replacing the battery, always carry out procedures in “M. ALL RESET”.
If you do not, the watch may not work correctly.
48
To Next Page
Loading...
