< Switching modes during chronograph measurement >
Measurement continues even if you press button
M
during chronograph mea-
surement and switch to another mode. It is therefore possible to return to the
chronograph again to show the continued measurement. However, if you switch
to the Dive Mode of the Diving Modes, chronograph measurement is cancelled
and the watch returns to the reset display.
Split time: The time elapsed from the start.
< Accumulated time measurement >
(1) Press button
A
to start or stop.
(2) When stopped, press button
B
to reset.
• There is a confirmation beep upon
start, stop or reset operations.
< Split time measurement >
(1) Press button
A
to start or stop.
(2) Pressing button
B
during measurement displays a split time for about 10
seconds *1. (SP flashes on the display when a split time is being shown.)
You can make repeated split time measurements.
(3) When stopped, press button
B
to reset.
• There is a confirmation beep upon start, stop, split time or reset operations.
*1: The watch automatically returns
to the measuring display after
10 seconds.
30
31
RESET MEASURE STOP
RESET MEASURE
SPLIT TIME
STOP
A
A
B
A
A
A
B
B
* If the watch is left for about 3 minutes in Chronograph Mode in the reset
state, it automatically returns to the Time/Calendar Mode.
Start Goal
Split time
Split time
*1
A
To Next Page
Loading...
Need help?
General
