Citizen CBM-910 Type II - Page 24

— 20 —
<Contents of Memory Switch Setting>
In square brackets ([ ]), choose one of the options for each setting item. Item
marked * is the default setting.
1. Country (Selecting international character set)
[*USA, FRA, GER, U.K, DEN, SWE, ITA, SPE, JPN]
Selects a international character set.
For international character set, refer to International Character Code Table.
USA = U.S.A SWE = Sweden JPN = Japan
FRA = France ITA = Italy GER = Germany
SPA = Spain U.K = U.K. DEN = Denmark
2. Code page (Selecting code page)
[CP-437, Katakana, CP-858, CP-860, CP-863, CP-865, CP-852, CP-866, CP-857,
Windows, CP-864, CP-869, *910Intl, *910JPN, Space]
Selects a code page.
For code page, refer to Character Code Table.
Among the character sets for model type, model F is defaulted to 910Intl
and model J to 910JPN.
CP-437 = Codepage PC437 Katakana = Katakana
CP-858 = Codepage PC858 CP-860 = Codepage PC860
CP-863 = Codepage PC863 CP-865 = Codepage PC865
CP-852 = Codepage PC852 CP-866 = Codepage PC866
CP-857 = Codepage PC857 Windows = Codepage WPC1252
CP-864 = Codepage PC864 CP-869 = Codepage PC869
910Intl = 910 Emulation (International) 910JPN = 910 Emulation (Japan)
Space = Blank page for user’s setting
3. Emulation (Selecting 910/3110 Emulation)
[*CBM-910, iDP-3110]
Sets command system to 910 Emulation or 3110 Emulation.
4. ACK Timing (ACK timing)
[Before, Center, *After] *1
ACK output timing for parallel I/F can be changed in 3 steps.
For details, refer to the description of Parallel Interface.
5. P.N.E. Sensor (Enable/Disable paper-near-end)
[*Enable, Disable]
This setting allows selection between Enable/Disable of paper-near-end
sensor.
6. P-ON Sel (Online status at Power ON)
[*Select, Deselect]
Selects the status of the SEL switch on the operation panel at power ON.