— 30 —
6.5 Error Detection
● Communication error
• Parity error
Parity error occurs when parity check is specified and parity is not observed in
the even and odd parity checks.
• Framing error
When space state detected on detection of stop bit.
• Overrun error
When next following data having been transferred to receiving buffer register
regardless of presence of data in that receiving buffer register.
On occurrence of the above error, convert data at the time of occurrence into ■ (7FH)
to print it out.
RECEIVING CONTROL AND BUFFERING
This equipment controls, on receipt of print data, receiving (DTR Control) in one-word
unit. If the host disregards DTR and carries out data transmission at this time, over-
run of receiving data may be resulted. This state should be avoided on the host’s
responsibility. (The data discharging type host cannot follow this.) This is applicable
when the host adopts a double buffer type transmitter.
To Next Page
Loading...
Need help?
General
