— 42 —
In 3110 emulation
Following ESC + & + 01 (Note) + 41H + 42H
sending data 80H, 00H, 81H, 00H, 89H, 00H, 89H, 00H, FFH
00H, 89H, 00H, A9H, 40H, 81H, 00H, 80H, 00H
allows “
” to be registered at 41H and 42H.
[Printing registered character]
To print a registered character, executing Activate Registered Character
command (ESC + “%” + 1) may be required in some case. If you want to
return to the internal characters, it is necessary to disable the registered
characters. Refer to the description for Valid/Invalid of Registered Characters
command.
Note: With 0 being set in “C1” parameter even if data have been registered
in the uppermost position, letter image registered is made incomplete.
321 654 987 321 65
41H 42H
4 987
As this printer takes half-dot printing system, dots cannot be aligned
continuously in printing (horizontal) direction. Therefore, even if any pattern
is specified at point “*” at the right of point “●” above, it cannot be registered
as a pattern.
Configuring a double width character by registering the data for 2 characters
is also possible.
<Example> When registering a Japanese character “
” by using two
characters 41H and 42H
321 654
1
2
3
4
5
6
7
0
1 2 3 4 5 6 77
41H 22H 55H 08H 41H 00H 41H
*
*
*
*
*
*
To Next Page
Loading...
