33
Printer Operation
3. Push the large blue head-open lever to release the head unit.
Pull out the ribbon from the bottom of the head unit to the
ribbon winding side.
4. Using tape etc., fix the ribbon that you have pulled out on the
ribbon holder on which the paper core has been set and wind it
on the ribbon holder.
Winding side
ribbon holder
Setting the Ribbon
5. Set the ribbon holder on which the paper core has been set in
the ribbon drive unit, then rotate it in the direction shown by
the arrow to remove slack and wrinkles from the ribbon.
To Next Page
Loading...
Need help?
General
