—13—
FEED button
Press this button to feed paper.
In case of a cutter lock, remove the cause of the lock, close the paper cover, and
then press the FEED button.
The printer enters the mode for setting memory switches and running self test.
Operation panel
The operation panel has five LEDs and two buttons.
Refer to 4.3 Self Test
Refer to 5.3 Manual Setting of Memory Switches
LED name Color Description
POWER LED Green Lights when the power is on, turns off when the power is off.
PAPER LED Green Lights or flashes when no paper or low paper is detected.
May also light or flash when other abnormalities are detected.
CUTTER LED Green Flashes when a cutter error is detected.
May also light or flash when other abnormalities are detected.
COVER LED Green Lights or flashes when an open paper cover is detected.
May also light or flash when other abnormalities are detected.
SERVICE LED Orange Flashes when an unrecoverable printer abnormality is
detected.
Refer to 4.5 Error Indications
To Next Page
Loading...
