58
——
4.2 Clearing a Cutter Error
If the auto cutter stops during the auto cutter operation with the blade of the auto cutter
in the open position due to foreign matter entering, paper jamming, etc., the CUTTER
LED ashes. When a cutter error occurs, resolve the cutter error with the following
procedure.
1. Turn on the power.
2. Push down the cover open lever to open the paper cover.
3. Remove any jammed paper including any scraps of paper. (Remove the paper roll that
is loaded in the holder also.)
4. Reload the paper roll and close the paper cover.
CAUTION
When opening the paper cover, be careful not to touch the entrance of the blade of the auto
cutter.
The print head is very hot immediately after printing. Be careful not to touch it with your
hands.
Do not touch the print head with bare hands or metal objects.
Refer to PRECAUTIONS IN HANDLING THE PRINTER
To Next Page
Loading...
