- 55 -
• Press the UNITS key. Mass of component 1 is recorded in the balance memory.
The information on the display changes:
component 2, mass WGH, IC=1, SUM=. . . .
• Information on the display is settle do zero.
• Repeat it for all components
• After weighing last component and write its mass to the balance memory (the
UNITS key) total mass of mixture and prompts to following steps are displayed.
Procedure of making mixtures without recording components and their mass date in
the balance memory
If documentation of preparing mixture is printed set the parameter 02 Printout at 1 : YES.
If mass of each component is confirmed each mass with their names is printed on
connected printer or computer.
• Set the parameter 01 Prompts at the value 0 : NO
• Enter function Recipes by pressing ENTER
• Tare container mass to the balance memory
• Pour component 1 to the container – in relation to information about mixture
• Press the UNITS key. Mass of component 1 is recoded in the balance memory.
The information on the display changes: IC=1, SUM=. . . The indication is set to
zero. Press the key Units
• Repeat it for all components of the mixture
• After write last component press the →0/T←. Procedure of making mixtures is
finished. Sum of mixture is kept on the display.
• Press PRINT to print(send) report of made mixture
Statistics counting
Statictics counting relate only to making mixtures (particular mass components are not
included in the counting).
If user performs statictic counting in this work mode:
1. enter the parameter 06 Statistics
2. cancell previous results of statistic counting
3. set the parameter 06 01 Statistics at YES
4. enter work mode for preparing mixtures
5. perform measurement series
6. enter the parameter 06 Statistics again
7. enter the parameter 06 02 Results
8. to print results press the key PRINT
To Next Page
Loading...
