- 77 -
Function SWITCH CONSTANCE TRANSMISSION IN BASIC INTERVAL
Command C0 CR LF
Function SWITCH CONSTANCE TRANSMISSION IN BASIC INTERVAL
Command C1 CR LF
Function SWITCH CONSTANCE TRANSMISSION OFF IN ACTUAL
Command CU0 CR LF
Function SWITCH CONSTANCE TRANSMISSION ON IN ACTUAL
Command CU1 CR LF
Function NUMBER OF THE BALANCE
Command NB CR LF
Function RANGE OF WEIGHIGN
Command FS CR LF
Function PROGRAM VERSION
Command RV CR LF
Function WRITE OR CHANGE DATE IN THE BALANCE
Command PD CR LF (the balance sends settled date or the date is changed)
Function WRITE NEW OR CHANGE TIME IN THE BALANCE
Command PD CR LF (the balance sends settled time or this time is changed)
Function WRITE ACTUAL WORK MODE
Command PM CR LF
Function SEND SETUP
Command PS CR LF (all balance setup is sent – printout of the parameters)
Function SOUND SIGNAL – „BEEP“
Command B CR LF (sound beep is switched on)
Function SEND LAST ERROR CODE
Command ER CR LF (last order of the error is sent)
Function DISPLAY STRING
Command DS CR LF (signs are shown on the display)
Function CANCELL STRING
Command CS CR LF (cancels string and restores previous state of the display)
Function DISPLAY HEADLINE
Command DH CR LF (sings are displayed in top headline of the display)
Function CANCELL HEADLINE
Command CH CR LF (cancels information in the top headline)
To Next Page
Loading...
