Citizen E610 - Correcting the Reference Position

158
B. Correcting the Reference Position
• The reference position is corrected by repeating correction for each parameter in the
order of seconds
 hour ⁄ minute hands  date (function hand turns) each time
button (B) is pressed.
Pull the crown out to Position 1 and turn to align the mode hand at
u
0
t
(reference
position). When the crown is then pulled out to Position 2, the second hand turns
continuously in the clockwise direction and then stops to indicate that the watch has
entered the reference position correction mode.
(1) Turn the crown to align the second hand at the reference position (0 hours).

Turning the crown to the right (by one click) causes the second hand to advance by
one second.
Seconds Hour ⁄ minute hands
[Change in Corrected Location]
Button (B) Button (B) Button (B)
Date (function hand)