Citizen H145 - Troubleshooting Detailed Solutions; Post-reset setup steps

51
After performing All Reset
You must set the watch again following the procedure below.
1. Correct the current reference position.
After performing All Reset, the watch is in reference position correction mode.
See from step 4 on page
44
.
2. Select a city.
See pages
12
to
15
.
3. Adjust the time/calendar.
• When adjusting by receiving the time signal manually:
See pages
24
and
25
.
• When adjusting manually:
See pages
38
to
41
.
1.
Pull the crown out to position
.
2.
Press the upper and lower right buttons and , then release them.
The second hand moves to the “0” second position, the hour hand and date indicator
move slightly, and the watch is reset.
Troubleshooting
EN_H145[DOM]-f.indd Sec1:51EN H145[DOM]-f.indd Sec1:51 11.3.29 5:17:40 PM11.3.29 5:17:40 PM