iDP-562 User’s Manual
CITIZEN 4
3.2 Description on Each Part
1 Power Plug Insert this plug in the plug socket under the prescribed voltage.
2 Power Switch As the power switch is turned on, initializing performance of the printer starts and the
print head returns to the left end (home position).
3 Power Lamp The lamp lights up as power switch is on and turns off when the switch is off.
4 SEL Lamp The lamp lights up when the printer is in a SELECT (ON-LINE) state and is
extinguished by DESELECT (OFF-LINE) state of the printer.
The printing operation is maintained while this lamp keeps on lighting.
5 ALM Lamp This lamp is turned on when the printer operation is out of normal condition.
When this ALARM state happens, printing and Line Feed operation is suspended. For a
release from an ALARM state, push SEL switch or turn off the power switch once and
turn on again.
6 LF Switch Use this switch for paper feeding and line spacing when the printer is in DESELECT
state.
7 SEL Switch When this switch is pressed, the printer enters SELECT (ON-LINE) status.
When pressed again, the printer enters DESELECT (OFF-LINE) status.
This switch is also used when clearing an alarm condition.
And if this switch is pressed when printing, the printer enters DESELECT status, after all
the data in the buffer is printed.
8 Printer Cover Set this cover correctly in place so that dusts and noise can be avoided.
9 Interface Connector This is for connection with various personal computers by connecting cable.
Make sure that both your computer and printer are powered off before connecting cable.
To Next Page
Loading...
Need help?
General