Citizen u700 - Reference Position Adjustment; Adjusting Reference Position

4342
Checking and correcting the current reference position Checking and correcting the current reference position
• The correct time is not displayed on the analog
section even after the time setting.
•
Each chronograph hand does not point to “0/.00”,
“0 (or 60)” even after resetting the measurement.
1.
Press button
M
to change the mode to
Chronograph. (“CHR”)
2.
Pull out the crown to position
1
.
“0” is displayed and all hands
move to indicate the current
reference position.
• Go to step 5 on page 45
when the reference position is
correct. (0:00:00/measurement time: 0)
Continued on the next page
24
12
18
.01
50
10
20
30
0
40
.02
.03
.04
.05
.06
.07
.08
.09
.00
6
0
1
2
3
4
5
6
7
8
9
1/1000Sec.
60
30
25
20
15
10
05
55
50
45
40
35
01
■ Adjusting the reference position
Adjust the reference position in the following cases:
Button M
Button A
Button B
Crown
24-hour
hand
1/10 chronograph second hand
1/100 chronograph second hand
Chronograph
second hand
“CHR”