CITROEN AMI 2021 - Battery Handling and Jump-Starting

28
In the event of a breakdown
Number plate lamp
Removing
► Lie down behind the vehicle in the middle of
the rear bumper.
► Pass your arm behind the bumper to reach
the lamp above the foam shock absorber.
► Pinch the xing clip holding the lamp.
► Push the lamp down while holding the xing
clip.
► Disconnect the lamp from its wiring loom.
► Leave the wiring loom dangling through the
bumper.
Retting
► Connect the new lamp to the suspended
wiring loom.
► Replace the lamp into its housing by pressing
it until it clips into place.
Changing a fuse
Before changing a fuse:
► Identify the cause of the fault and x it.
► Switch o󰀨 all power consumption.
► Immobilise the vehicle and switch o󰀨 the
ignition.
► Identify the defective fuse using the current
allocation tables and diagrams.
To replace a fuse, it is essential to:
► Pull the fuse out of its housing and check the
state of its lament.
► Always replace the failed fuse with a fuse of
the same rating (same colour); use of a di󰀨erent
rating may cause malfunctions - risk of re!
If the fault recurs soon after replacing a fuse,
have the electrical system checked by a dealer
or qualied workshop.
Good Faulty
The fuse allocation tables and
corresponding diagrams are available
through a dealer or qualied workshop.
Replacement with a fuse not shown in the
allocation tables could cause a serious
malfunction of the vehicle. Consult a dealer or
qualied workshop.
Installing electrical accessories
Before tting other electrical equipment
or accessories to your vehicle, contact a
dealer or a qualied workshop.
The Manufacturer accepts no responsibility
for any costs incurred in repairing the vehicle
or for rectifying malfunctions resulting from
the installation of accessories not supplied
or not recommended by the Manufacturer
and not installed in accordance with its
recommendations, in particular when the
combined power consumption of all of the
additional equipment connected exceeds 10
milliamperes.
Accessing the fuses
► Turn both xing screws a quarter turn.
► Unclip the access cover.
► Pull out the faulty fuse and replace it.
www.carobook.com