31
In the event of a breakdown
8
Removing the battery
► Disconnect the negative terminal rst (left-
hand side), next disconnect the positive terminal
(right-hand side):
• Unscrew and remove the screw from the
clamp.
• Remove the clamp from the terminal.
► Make sure that any disconnected clamps
do not come into contact with the battery
terminals - Risk of short-circuit!
► Unscrew the 2 xing screws on the battery's
retainer brace.
► Remove the retainer brace and then the
battery.
Retting the battery
► Place the battery into its compartment.
► Replace the retainer brace and its 2 xing
screws.
► Reconnect the positive terminal rst (right-
hand side), next reconnect the negative terminal
(left-hand side):
• Insert the nut horizontally into the terminal's
square housing.
• Place the clamp on top of the terminal.
• Insert the screw into the terminal and nut
and screw tight.
Retting rear bumper
► Bring the bumper close to the frame.
► Pass the lamp's suspended wiring loom in
front of the bumper.
► Connect the indicator wiring looms.
► Place it in position and then push the bumper
horizontally until the attachment points clip into
place.
► Screw the 2 upper side xing screws into the
aps.
► Screw the 2 lower side xing screws into the
wheel arches.
► Screw the 2 lower xing screws into the
frame.
► Clip the 2 upper access aps to the wings.
► Finally, replace the number plate lamp.
For more information on the Number plate
lamp, refer to the corresponding section.
Starting using another
battery
If the vehicle's battery is at, the motor can be
started using a backup battery (either external or
from another vehicle) and jump leads or using a
battery booster.
Never start the motor by connecting a
battery charger.
Never use a 24 V or higher battery booster.
Check beforehand that the backup battery
has a nominal voltage of 12 V and a capacity
at least equal to that of the discharged
battery.
The two vehicles must not be in contact with
each other.
Disconnect or turn o all electrical devices in
both vehicles (portable devices, radio, wipers,
lights, etc.).
Do not disconnect the (+) terminal while the
motor is switched on.