120
Visibility
E3_en_Chap06_visibilite_ed01-2014
Headlamp adjustment
To avoid causing a nuisance to other road
users, the height of the headlamps should be
adjusted in relation to the load in the vehicle.
The initial setting is position "0".
Travelling abroad
The design of the dipped beam
headlamps allows, without modification,
driving in a country that drives on the
other side of the road to the country in
which your vehicle was sold.
0. Driver only
or driver + front passenger.
-. Driver + front passenger + rear
passengers.
1. Driver + front passenger + rear passengers
+ load in the boot.
-. Driver + front passenger + rear passengers
+ load in the boot.
2. Driver only + maximum authorised load in
the boot.
This position is sufficient to avoid causing dazzle.
Higher settings may limit the spread of light
from the headlamps.
To Next Page
Loading...
