208
Practical information
E3_en_Chap09_info_pratiques_ed01-2014
Changing a wiper blade
F Within one minute after switching off
the ignition, operate the wiper stalk to
position the wiper blades vertically on the
windscreen.
Removing
F Raise the corresponding wiper arm.
F Pull on the screenwash delivery pipe to
disconnect it from the jet (located on the
wiper blade).
F Unclip the wiper blade and remove it.
Fitting
F Put the corresponding new wiper blade in
place and clip it.
F Connect the screenwash delivery pipe to
the jet on the wiper blade.
F Fold down the wiper arm carefully.
After fitting a front wiper
blade
F Switch on the ignition.
F Operate the wiper stalk again to park the
wiper blades.
Before removing a front
wiper blade
To Next Page
Loading...
